Conveyor Belts



Start out making two sectors, one inside the other, and fairly long. Switch to 3d mode and raise the floor height of the inner-island sector above the outer sector.


Insert a SE within the island sector. Change the SE lotag to 24. Change the angle of the SE-24 to the direction you want the belt to move. Switch over to 3d mode and make the floor of the inner sector Relatively Aligned. To set the Relative Alignment, point the crosshair at the floor tile and hit 'R'.


You can set the hitag equal to a switches' lotag to turn the conveyor belt on and off. Just set the lotag to some unique switch number and set the hitag of your SE-24 to the same number.

Download this page locally



Duke Nukem 3D is copyright ©1996 , All Rights reserved.

THIS PAGE IS NOT MADE BY OR SUPPORTED BY 3D REALMS

Copyright ©1996 Tyler Matthews, All Rights reserved.
Go back to my Duke FAQ BUILD page
Go back to my Duke FAQ BUILD page Text-Only